Flagpole Buddy Starlink (2nd Gen) Kit

Item Description

The Starlink 2nd Generation (Rectangular) Dishy works best above the roof of the RV.

Our Starlink Kit allows you to install the dish above the RV safety without climbing the Ladder.  With our patented mounting system, the pole angles in from ground level and secures the pole in two places.  

Unlike telescoping poles, our 2 inch diameter aluminum pole comes in 4ft sections for storage.  The pole uses a combination of a swaged diameter and dual spring buttons to create a sturdy pole for your dish. 

The Starlink Post locks into our Adapter.  The Adapter is design to allow the Starlink Cable to run either on the outside or inside of the pole.  

Compared to a “Single” pole holding mount, our “Two” mount FlagPole Buddy pole holding system distributes the wind loading stresses throughout all ladder supports.   

Kit comes with:

• (1) Starlink Adapter (Goldish color)
• (2) 4ft Aluminum Pole Sections (20 Gage @ 2inch dia.) Spring Buttons 
• (1) 2.0 FlagPole Buddy Mount set (fits standard 1.00" diameter ladder)

Don't leave the your $500 Dishy to some DIY project, Collapsing Telescoping Pole or Unreliable Suction Cups!  

Get the Industry Proven FlagPole Buddy Starlink Kit.

STARLINK EQUIPMENT NOT INCLUDED

NOTES:

 - If you run the Cable inside, the drain hole in our 2.0 Lower Mount (Cup) will need to be enlarged to fit the Starlink Cable Plug (.53")

 - It is not Recommended to fly a flag with the Starlink

 - It is not recommended to Drive with the Starlink installed

 - It is not recommended to use more than (4) pole extensions 

 - Be carful around Power lines

 - Take down in high winds 

Material : PETG or PolyEthylene Terephthalate Glycol is a thermoplastic polyester commonly used in manufacturing. PETG has good impact resistance and ability to withstand high temperatures.